سلام
بهم گفتن باید این سیستم فعال بشه ...
از طریق ماکروسافت یک اموزش پیدا کردم ، اما چند جارو متوجه نشدم ، لطفا در مورد جاهایی که قرمز رنگ کردم توضیح بدید

و ایا راه فعال سازی این سیستم همینی هست که در زیر نوشته شده ؟


How to Configure SNMP Agent Information

To configure SNMP agent information:
  1. Click Start, point to Control Panel, point to Administrative Tools, and then click Computer Management.
  2. In the console tree, expand Services and Applications, and then click Services.
  3. In the right pane, double-click SNMP Service.
  4. Click the Agent tab.
  5. Type the name of the user or administrator of the computer in the Contact box, and then type the physical location of the computer or contact in the Location box.
    These comments are treated as text and are optional.

منظور از کاربر یا مدیر کامپیوتر چی هست ؟
خواسته ادرس فیزیکی کامپیوتر یا اتصالات رو وارد کنم ، من آی پی سرور رو زدم ، در واقع باید چی وارد بشه ؟


  1. Under Service, click to select the check boxes next to the services that are provided by your computer. Service options are:
    • Physical: Specifies whether the computer manages physical devices, such as a hard disk partition.
    • Applications: Specifies whether the computer uses any programs that send data by using TCP/IP.
    • Datalink and subnetwork: Specifies whether this computer manages a TCP/IP subnetwork or datalink, such as a bridge.
    • Internet: Specifies whether this computer acts as an IP gateway (router).
    • End-to-end: Specifies whether this computer acts as an IP host.
  2. Click OK.

NOTE: If you have installed additional TCP/IP network devices, such as a switch or a router, see Request for Comments (RFC) 1213 for additional information. To view RFC 1213, visit the following Internet Engineering Task Force (IETF) Web site:

http://www.ietf.org/rfc/rfc1213.txt
Microsoft provides third-party contact information to help you find technical support. This contact information may change without notice. Microsoft does not guarantee the accuracy of this third-party contact information.

Back to the topHow to Configure SNMP Communities and Traps

To configure traps:
  1. Click Start, point to Control Panel, point to Administrative Tools, and then click Computer Management.
  2. In the console tree, expand Services and Applications, and then click Services.
  3. In the right pane, double-click SNMP Service.
  4. Click the Traps tab.
  5. In the Community name box, type the case-sensitive community name to which this computer will send trap messages, and then click Add to list.
  6. Under Trap destinations, click Add.
  7. In the Host name, IP or IPX address box, type the name, IP or IPX address of the host, and then click Add.
    The host name or address appears in the Trap destinations list.

منظور از case-sensitive چی هست ؟
در اسم هاست باید چه آی پی ای وارد بشه ؟
.