bot
March 13th, 2015, 02:46
سلام
دی ان اس هایی که روی سرورم در هتزنر میسازم عمل نمیکنند
یکی از دوستان فرمودن در هتزنر باید تنظیمات شبکه صورت بگیره تا درست عمل کنه و این آموزش رو دادن
http://www.directadmin.com/installguide.html
قسمت زیر در آموزش بالا رو چجوری باید انجام بدم؟
Special notice for VPS/VDS installs:
After the install, add:
ethernet_dev=devicename
for example, on many vps systems it will be:
ethernet_dev=venet0:0
other systems where the IP is not the base IP on the device, you'd need to simply set the correct number:
ethernet_dev=eth0:1
or other systems with the IP on a different device, it might be:
ethernet_dev=eth1
type: /sbin/ifconfig
to see which device your IP is in.
to /usr/local/directadmin/conf/directadmin.conf.
Replace devicename with the FULL devicename reported by ifconfig. If your VDS/VPS system emulates eth0, then you may skip this step.
دی ان اس هایی که روی سرورم در هتزنر میسازم عمل نمیکنند
یکی از دوستان فرمودن در هتزنر باید تنظیمات شبکه صورت بگیره تا درست عمل کنه و این آموزش رو دادن
http://www.directadmin.com/installguide.html
قسمت زیر در آموزش بالا رو چجوری باید انجام بدم؟
Special notice for VPS/VDS installs:
After the install, add:
ethernet_dev=devicename
for example, on many vps systems it will be:
ethernet_dev=venet0:0
other systems where the IP is not the base IP on the device, you'd need to simply set the correct number:
ethernet_dev=eth0:1
or other systems with the IP on a different device, it might be:
ethernet_dev=eth1
type: /sbin/ifconfig
to see which device your IP is in.
to /usr/local/directadmin/conf/directadmin.conf.
Replace devicename with the FULL devicename reported by ifconfig. If your VDS/VPS system emulates eth0, then you may skip this step.